7
The indicator light flashes yellow
and the 3 beverage buttons flash
white.
7. Press the middle button
(caffè crema).
The pump starts to operate.
As soon as the pipes are filled
with water, the pump stops
automatically. A small quantity
of water runs into the cup
underneath the spout. You will
then hear 2 beeps.
Only the 3 beverage buttons will
continue to flash; the machine is
heating up to brew coffee.
As soon as the machine has heated
up, you will hear a beeping sound.
The 3 beverage buttons will remain
permanently lit.
8. Pour away the water in the cup and rinse the machine twice as described in the
“Rinsing the machine” section.
The machine is then ready for use.
Rinsing the machine
After switching the machine on for the first time, or if you have not used the
machine for longer than 2 days, rinse the machine by allowing 2 cups of water
to flow through it (without a capsule).
1. Fill the water tank up to the
MAX
mark with fresh, cold
tap/drinking water.
2. Fold down the lever if necessary.
3. Place an empty cup underneath
the beverage spout.
4. If necessary, press one of the
3 beverage buttons to switch on
the machine.
You will hear a short beeping
sound.
5. Once all 3 beverage buttons are
permanently lit, press the middle
button (caffè crema). The pump
will flush water through the
pipes, which will then run into the
cup underneath.
The machine will beep once the
rinsing process has finished.
