English
• 25 •
7-
When it has finished warming up, the machine dispenses the
frothed milk directly into the glass. The machine will stop dis-
pensing when it reaches the preset quantity. The dispensing
process can be stopped early by pressing the Frothed milk but-
ton .
When the machine has finished preparing the Frothed
milk, the rinse button will light up to remind you
that the milk circuit must be rinsed; see the section ''rinsing
the milk circuit'' in this chapter.
adjusting the amount of frothed milk
The machine allows you to adjust the amount of frothed milk pre-
pared according to your taste and the size of your glass.
Before preparing the frothed milk, check that the
On/Off button and beverage buttons are con-
stantly lit and that there is enough water in the tank.
Proceed as follows to set the desired quantity of Frothed milk :
1-
Insert the carafe into the machine and ensure that the milk is
above the MIN level.
2-
Place a glass underneath the milk dispensing spout as indicated
in paragraph “Dispensing height adjustment”.
3-
Press and hold the Frothed milk button for 3 seconds until it
flashes in brief intervals. Then release the button.
4-
Press the Frothed milk button again when the amount of
milk in the glass reaches the desired level.
At this point the Frothed milk button has been reprogrammed.
Each time it is pressed, the machine will prepare the same amount
of frothed milk that was just programmed.
Minimum quantity of milk that can be set: approx. 50 ml
Maximum quantity of milk that can be set: approx. 300 ml
Preset quantities:
Frothed milk: approx. 100 ml
restoring the pre-set quantities
To reset beverages to their factory settings, with the machine off,
press and hold the On/Off and Filter coffee
(blue) buttons
for 5 seconds. All the buttons will flash twice in confirmation.
latte macchiato
Before dispensing the Latte macchiato, check that
the On/Off button and beverage buttons are
constantly lit and that there is enough water in the tank.
1-
Insert the carafe in the machine and ensure that the milk is
above the MIN level.
2-
Adjust the machine to fit the glass into which your latte mac-
chiato will be dispensed (see section ''Adjusting the Dispensing
Height'').
3-
Place a glass under the coffee and milk
dispensing spouts.
4-
DO NOT insert a coffee capsule into the
capsule compartment.
5-
Press the Frothed milk button .
6-
The Frothed milk button flashes;
the machine is warming up.
7-
When it has finished warming up, the
machine dispenses the frothed milk directly into the glass. The
machine will stop dispensing when it reaches the preset quan-
tity. The dispensing process can be stopped early by pressing the
Frothed milk button .
make sure there is enough space in the glass for the
coffee when dispensing the milk.
Fig.1
Fig.2
Fig.3
8-
Lift the capsule compartment opening lever
(Fig.1)
.
9-
Insert the capsule
as shown
in the figure
(Fig.2)
.
10-
Lower the lever to close the capsule compartment
(Fig.3)
.
11-
Press the
(white) button for an Espresso, the
(yellow)
button for a Caffè crema or the
(blue) button for a Filter
coffee.
12-
Coffee brewing stops automatically when the set level is
reached. However, it is possible to stop the dispensing process
early by pressing the same button as the beverage being dis-
pensed.
