32
Adjusting the strength of the beverage (beverage quantity)
Adjust the strength of the beverage to suit your personal taste by
adjusting the quantity of water. You can do this for one single brewing
procedure or save the setting.
Adjusting the strength for the current brewing procedure (without
saving the setting)
M
If the beverage is
too weak
for your taste, you can stop the water flow
prematurely by pressing the flashing beverage button.
M
If the beverage is
too strong
for your taste, simply start the brewing
process again without inserting a new capsule. Press the button again
as soon as sufficient water has run through.
Default settings upon purchasing the machine:
Espresso
approx. 40 ml I
Caffè crema
approx. 125 ml
Black coffee
approx. 125 ml
Setting the strength beverage permanently (saving the setting)
You can also permanently change the factory settings for the beverage
quantities. You can customise one setting for each beverage button:
one each for espresso, caffè crema and black coffee.
1. Fill the water tank, insert a capsule and place a cup underneath the
beverage spout.
2. Press and hold the required
button (e.g.
Caffè crema
).
You will hear a beep after ap-
prox. 2 seconds. Release the
button as soon as the desired
quantity of coffee has been
dispensed into the cup.
You will hear two beeps.
The setting has been saved. If the settings are not to your taste, simply
repeat the procedure to change them again.
Restoring the factory settings
To reset to the original amounts of beverage, proceed as follows:
1. Switch the machine off: To do
so, briefly press the
Espresso
button and the
Caffè crema
button simultaneously.
2. Then hold the
Caffè crema
and
Black
coffee
buttons
down simultaneously.
3. Also briefly press the
Espresso
button once. All beverage but-
tons will flash in confirmation.
4. Release all buttons.
The factory settings for beverage quantity have been restored.
en
113420 en Cafissimo Pure+ v6.indd 32
113420 en Cafissimo Pure+ v6.indd 32
06.01.23 15:20
06.01.23 15:20
