7
Rinsing the machine
After switching the machine on for the first time or if you have not used the
machine for longer than two days, rinse the machine by allowing two cups of
water to flow through it (without a capsule).
1. Fill the water tank with fresh, cold tap
water or drinking water up to the MAX
mark.
2. Place an empty cup beneath the spout.
3. The lever must be in the down position.
4. As soon as the three coffee buttons
remain permanently lit, press the middle
one.
The pump will flush water through the pipes to be dispensed into the cup below.
5. Pour the water away.
Repeat steps 2 to 4.
6. Finally, empty the drip tray. To do so, pull
the drip tray and used capsule container
out together and remove the grid.
MAX
The finest aroma – the finest flavour
One capsule per cup
Each capsule is a single portion for one cup.
Full aroma
Only insert a capsule when you intend to use the machine. The capsule is pierced
as it is inserted. If it is not used immediately, the aroma will fade.
Preheating the cup
Fill the cup with hot water and then pour it away shortly before using the cup.
This helps espresso, caffè crema and filter coffee taste their best.
Coffee strength
Adjust the strength of the coffee to suit your personal taste by changing the
quantity of water. This is very easy to do, and is described in the section
“Adjusting the strength of the coffee”.
Using large / small cups or glasses
For large cups, leave
the drip grid in place.
For small cups, simply
turn the drip grid over.
For glasses, remove the
whole drip tray.
