8
As soon as the three coffee buttons remain
permanently lit the machine is ready for use.
5. Press the coffee button that corresponds to the capsule you have inserted.
The brewing process starts and stops automatically.
As is the case with professional espresso
machines, a small quantity
of coffee is pre-brewed. This enhances the
aroma. This process can be identified by the
short pause at the beginning of the brewing
process.
Filter coffee is prepared without a
pre-brewing process, just like with standard
coffee machines.
Tip:
You can adjust the strength of the coffee by
adjusting the quantity of water. Refer to the
section “Adjusting the strength of the coffee”
for information on how to do this.
If you would like to stop the brewing process prematurely, press the same coffee
button again while brewing.
6. Before removing the coffee cup, fold back the
lever as far as it will go.
The machine loses pressure and a little more
coffee will escape. The capsule then falls into
the used capsule container.
=
white
coffee button
black
capsule
=
yellow
capsule
yellow
coffee button
=
blue
coffee button
blue
capsule
1. Press the On/Off switch to switch on the
machine. If the machine is in standby mode
(see “Standby mode”), press a coffee button
or move the lever.
The three coffee buttons flash as the machine
heats up. The machine loses pressure as it heats
up. A little residual water may also escape from
the coffee spout at the same time.
2. Place a cup beneath the coffee spout.
3. Fold back the lever as far as it will go and
insert a capsule as illustrated with the lid
facing forwards.
The capsule must be intact:
Do not
pierce it and
do not
remove the capsule
lid or insert a misshapen capsule!
4. Fold the lever fully down.
This action pierces the base and lid of the
capsule.
Brewing coffee
