11
7. Place the lid back on the coffee
bean compartment. Press the lid
all the way on so that the aroma
protection seal can optimally
protect the aroma of the coffee
beans.
8. Plug the connection plug into
the back of the machine.
9. Insert the mains plug into an
easily accessible wall socket.
10. Press the On/Off button to
switch on the machine.
The hot water button flashes and
the heating up process starts.
The pump starts after a few seconds. A small amount of water is flushed through
the system and dispensed into the drip tray.
11. Pour out the water in the drip
tray if necessary.
12. Rinse out the machine twice
as described in the “Rinsing the
machine” chapter. The machine
is then ready for use.
Rinsing the machine
After switching the machine on for the first time, or if you have not used the
machine for longer than two days, rinse the machine by allowing two cups of
water to flow through it.
1. Press the On/Off button to switch
on the machine.
The hot water button flashes and
the heating up process starts.
The pump starts after a few seconds. A small amount of water is flushed through
the system and dispensed into the drip tray. Press the hot water button to stop
the rinsing process.
2. Slide the coffee spout up
or down as required.
3. Place an empty container
underneath the coffee spout.
4. Press the hot water button as
soon as all the buttons are lit up.
The pump will flush water through
the system to be dispensed into
the container below.
5. Pour the water away.
6. Repeat steps 4 and 5.
