61
Standby mode
Always switch the machine to standby mode after use by pressing the On/
Off button. The machine will then consume very little energy. If no button
is pressed for about 10 minutes, the machine will automatically switch to
standby mode. This is both a safety function and a way to save energy.
You have the choice between four lengths of time after which the machine
should switch off automatically: 10 minutes, 20 minutes, 30 minutes or
120 minutes. The different switch-off times can be set as follows:
1. When switching the machine
on or off, press and hold the
On/Off
button for approx. 5
seconds. 2 beeps sound:
One of the 4 buttons will light up permanently while the other 3 buttons
flash. The permanently illuminated button shows the currently set
switch-off time:
Machine off
after 10 minutes
Machine off
after 20 minutes
Machine off
after 30 minutes
Machine off
after 120
minutes
Adjusting the automatic flushing process
The factory settings for the machine mean that automatic flushing only
starts when the machine is cold. If the machine is still warm from recent
previous use, flushing will not be performed again when it is switched on.
A new flushing process will only be triggered when the machine has
sufficiently cooled down.
You can adjust the flushing process so that it takes place automatically
after each time the machine is switched on.
Requirements:
The machine is switched on and ready for use.
1. Press and hold the
On/Off
button and the
EasyClean
button for approx. 5 seconds
until you hear 2 beeps.
2. Release the buttons.
The automatic flushing process now takes place after each time the
machine is switched on.
M
To restore the default, temperature-dependent setting, follow
the exact same procedure.
en
106466 en Esperto_Pro_v5.indd 61
14.06.21 12:24