TCL-THOMSON Electronics R&D Center (Shen’Zhen Lab)
Chassis Name
NX56-LA
Serial No.
Issued on
2008-05-19
Page
Page 12 of 15
Updated on
2010-01-27
Version
2.2
C. C
olour curve:
OSD menu
Default Value
Description
Remark
COL0
0
Set the minimal colour when user
C
olour=0
COL50
32
Set the colour when user
C
olor=50
COL100
50
Set the maximal colour when user
C
olour=0
Set the value as
practical
requirement
D. Volume
curve:
OSD menu
Default Value
Description
Remark
VOL0
0
Set the minimal volume when user Volume=0
VOL10
38
Set the minimal volume when user Volume=10
VOL10
65
Set the minimal volume when user Volume=30
VOL50
71
Set the volume when user Volume=50
VOL80
77
Set the maximal volume when user Volume=80
VOL100
81
Set the maximal volume when user Volume=100
Set the value as
practical
requirement
2.
Enter P-Mode, press key “5” to select page “5”. Set the corresponding item to require
value. See below table 3.6.2 for detailed description.
Table 3.6.2: Producing parameter setup and option page “5”
OSD menu
Default Value
Description
Remark
0=EHT tracking only on vertical
Track. Mode
0
EHT tracking mode
1=EHT tracking on vertical and EW
VX Normal
25
4:3 mode vertical zoom
Don’t adjust, use default
VX Compr.
0
16:9 mode vertical zoom
Don’t adjust, use default
HBL
1
blanking Switch
0 =OFF,1 =ON
WBF
5
Wide start
Don’t adjust, use default
WBR
8
Wide blanking end
Don’t adjust, use default
GET OFFSET
0
Get offset
See below description
ColdRD 61
ColdGD 56
Cold color temperature R
and G drive offset
64= offset value 0 63= offset value
-1 65= offset value
ˇ
1 Adjust to
right value
ColdRC 61
ColdGC 66
Cold color temperature R
and G cut-off offset t
64= offset value 0 63= offset value
-1 65= offset value
ˇ
1 Adjust to
right value
WarmRD 72
WarmGD 71
Warm color temperature R
and G drive offset
64= offset value 0 63= offset value
-1 65= offset value
ˇ
1 Adjust to
right value
WarmRC 65
WarmGC 64
Warm color temperature R
and G cut-off offset
64= offset value 0 63= offset value
-1 65= offset value
ˇ
1 Adjust to
right value
Description for AUTO OFFSET and GET OFFSET:
The
“GET OFFSET”
can use to make the EEPROM copy by PE engineer. When the
PAL and NTSC geometry adjustment had finished, trigger the “GET OFFSET” from “0” to
“1” to store the geometry offset datum between PAL and NTSC in EEPROM.
