background image

2

Important Safety Instructions

1.   Read these instructions.

2.  Keep these instructions.

3.  Heed all warnings.

4.  Follow all instructions.

5.  Do not use this apparatus near water.

6.  Clean only with dry cloth.

7.  Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.  Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including 

     amplifiers) that produce heat.

9.  Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,

     and the point where they exit from the apparatus. 

10. WARNING

Please refer the information on exterior bottom enclosure for electrical and safety information 

     before installing or operating the apparatus.

11.  WARNING

:

 The mains plug is used as disconnect device, the disconnect device shall remain readily 

     operable.

12. When not in use and during movement, please take care of the power cordset, e.g. tie up the power 

     cordset with cable tie or something like that. It shall be free from sharp edges and the like that can 

     cause abrasion of the power cordset. When put into use again, please make sure the power cordset 

     being not damaged. If any damages found, please look for the service person to replace the power 

     cordset specified by the manufacturer or have the same characteristics as the original one.

13. No naked flame sources, such as lighted candles, should be placed on the apparatus.

14. Unplug this apparatus during lightning storms or when unused for long periods of time. 

15. Only use attachments/accessories specified by the manufacturer.

16. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, 

     or sold with the apparatus. When a cart is used, use caution when moving the 

     cart/apparatus combination to avoid injury from tip-over.

17. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been

     damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects 

     have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate

     normally, or has been dropped. 

18. For safe operation of the apparatus, observe these installation requirements:

     Keep at least 2 inches of ventilation space between the rear cover of the apparatus and the wall. 

     Keep at least 1 inch of ventilation space between the apparatus and all other surfaces. Do not allow 

     any of the apparatus’ ventilation openings to be blocked by objects that might obstruct them, such 

     

 

as newspapers, curtains, table-cloths or any other objects. Do not expose the apparatus to any external 

     heat sources. Do not place any heat sources such as candles, lamps, etc. on the apparatus. Do not expose 

     the device to high levels of humidity or to any possible sources of moisture. When disposing of used 

     batteries from the remote control, consult local regulations regarding proper disposal.  

19. If an outside antenna or cable system is connected to the product, be sure the antenna or cable system

     is grounded so as to provide some protection against voltage surges and built-up static charges. Section 

     810 of the National Electrical Code, ANSI/NFPA No. 70-2011 (Section 54 of Canadian Electrical Code,

     Part 1) provides information with respect to proper grounding of the mast and supporting structure, 

     grounding of the lead in wire to an antenna-discharge unit, size of grounding conductors, location of

     antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

     See following example:  

ANTENNA LEAD IN WIRE

GROUND CLAMP

ANTENNA DISCHARGE UNIT 
(NEC SECTION 810-20)

GROUND CLAMPS

GROUNDING CONDUCTORS 

(NEC SECTION 810-21)

ELECTRIC SERVICE
EQUIPMENT

POWER SERVICE GROUNDING 
ELECTRODE SYSTEM (NEC ART 

250, PART H)

Summary of Contents for 3 Series
















Reviews: