Colour Television Chassis: M123A
58
Factory settings
D-mode:
Enter D-Mode by pressing D-Mode ON/OFF key, and then you can enter the D-mode.
S-mode:
Enter S-Mode by pressing VOLUME DOWN key on the unit until the volume decrease to
minimum level, then press the DISPLAY key on the remote handset (don't release the volume key)
and you can enter S- mode.
After enter D-mode or S-mode, press OK, then press program up/down to select menu from
menu 1 to menu 22, press OK to enter the menu, press program up/down to select item, press
volume up/down to adjust the setting. Press D-mode again to quit factory mode.
You can also enter menu 1 to menu 19 directly by pressing digital button 1~9, 0, notebook, CAP,
Display, Sleep, Calendar, System/INS, Favourite, Return, Picture.
Menu 1 (Remote key: 1)
Item Remark
RC
R cut-off setting
GC G cut-off setting
BC
B cut-off setting
GD
G drive setting
BD
B drive setting
Menu 2 (Remote key: 2)
Item Remark
HIGH5
Height (50Hz)
VP50
Vertical position (50Hz)
VLIN5 Vertical linearity (50Hz)
VSC5 Vertical S correction (50Hz)
VBLK5 Vertical blanking start & stop [1C, bit 3 ~ 0]
VCEN5 Vertical center (50Hz)
Menu 2 (Remote key: 2)
Item Remark
HIGH6
60Hz height
VP60
Vertical position
VLIN6
60Hz Vertical linearity
VSC6
Vertical S correction (60Hz)
VBLK6
Vertical blanking start & stop [1CH, bit 3 ~ 0]
VCEN6
Vertical center (60Hz)
Menu 3 (Remote key: 3)
Item Remark
HPOS5
Horizontal position (50Hz)
Menu 3 (Remote key: 3)
Item Remark
HPOS6
Horizontal position (60Hz)
9. Alignment Procedures
Summary of Contents for CTR1042
