Factory Alignment Specification of normal SIACP
Page 7 of 12
1.6 HDCP Test
For HDCP compliancy, it’s needed to check whether the HDCP key has been well set.
2.Final
Assembly
Alignment
2.1 FactoryMenu
Follow the below steps to pop-up the Factory Menu in case of “
FactoryKey
” is disable
:
-
press RemoteControl key “
MENU
” to display main menu
- Select “Picture” and press “
OK
” key to enter the picture submenu
- Select “Contrast” item
-
press the subsequence RemoteControl keys “
9
”, “
7
”, “
3
” and “
5
”
Press RemoteControl key “
Return
” To pop-up the Factory Menu in case of “
FactoryKey
” is
enable.
The status of “
Factory Key
” can be changed in
Factory Menu
->
Hot
key
Press
RemoteControl “
OK
” key or “
RIGHT
” key to enter the submenu.
Press RemoteControl “
Menu
” key to go back to the root menu.
Press RemoteControl “
RIGHT
”or “
LEFT
” key to change the values.
Press RemoteControl “
OK
” key run the function.
Press
RemoteControl “
Exit
” key exit the factorymenu.
2.2 Entering to “P” Mode
Turned on the factory key to enter into “P” mode.The TV will display the following info in
bottom left corner in “P” mode.
-main version ***
-project ID ***
-P/PS/D ***
2.3 White Balance Alignment
Make sure that the picture mode is
“vivid
”, enter to
“P” mode
(
turned on the factory key
) and
switch off
“
Pic. Enhance
” in
Factory Menu
->
White Balance
before white balance alignment .
VGA
,
CMP
,
DTV
,
CVBS_PAL
Color Coordinates are relative to HDMI.
CVBS_SECAM
and
CVBS_NTSC
Color Coordinates are relative to CVBS_PAL.
Warm
and
Cool
Color Coordinates are relatives to
Normal
mode.
Only
HDMI(YUV 720p@60Hz)
input requires color temperature adjustment.
All the Relative
Matrix Offsets
should be set while doing alignment.
