6
Connections and Setup
Explanation of Jacks on TV
This section describes the jacks on the side/back panel of your TV. There are several
ways to connect components.
SPDIF OUT - DIGITAL AUDIO OUT (coaxial):
Use a digital coaxial cable to connect
your TV to a compatible audio receiver.
COMPONENT IN (CMPT)
Lets you connect a component that has component video
jacks, such as a DVD player or set-top box. ( Green jack for Y, Blue jack for Pb and
Red jack for Pr )
•
Y Pb Pr (Component Video):
Provides good picture quality because the video is
separated into three signals. Use three video-grade or component video cables
for the connection.
•
L/R AUDIO:
Provides left and right audio connection when using the CMPT
VIDEO input.
Red and white jacks for R AUDIO and L AUDIO connection.(
Note:
AV IN
and
COMPONENT IN
share the same
L/R AUDIO and Y/Video
input
jacks.)
AUDIO/VIDEO IN (AV IN):
Lets you connect a component that has composite video
jacks, such as a VCR, DVD player or set-top box. Green jack for VIDEO connection,
red and white jacks for R AUDIO and L AUDIO connection.
VGA (PC IN (VIDEO) ):
Connect your computer or other component with a VGA
output to this jack using a 15-pin,D-sub cable.
L/R AUDIO:
Provides audio connection when using HDMI 1/DVI IN jack for DVI or
when using PC VIDEO IN.
(
Note: DVI IN
and
PC IN
share the same
L/R AUDIO
input jacks of
COMPONENT IN
.)
Note:
If using a DVI component, remember to connect the audio cable because the
DVI cable carries only the picture signal, not the sound.
ANT/CABLE/SAT IN:
Lets you connect a coaxial cable to receive the signal from
your antenna, cable, or cable box, or satellite receiver.
USB:
Allows you to connect a compatible mass storage device.
HDMI 1 / DVI IN (High-Definition Multimedia Interface/Digital Visual Interface):
Provides an uncompressed digital connection that carries both video and audio data
MENU
INPUT
2012.
04.17
10:52
:30 +
08'00
'
蒋霞
光
数字签名人
蒋霞
光
DN
：
cn=
蒋霞光，
ou=Shenzhen
，
dc=com
日期：
2012.05.17
17:17:50 +08'00'
Buttons on TV
If you cannot locate your remote, you can use the TV panel buttons on your
TV to operate many TV features.
CH+/-
Selects channels stored in the channel list or acts as the up/
down arrow (▲/▼) through the menu items.
VOL+/-
Increases/decreases the volume or acts as the right/left
arrow (◄/►) through the menu items.
VOL+
also acts as the
OK
button when in the menu system.
MENU
Brings up the TV’s main menu.
INPUT
Selects the signal source.
(
POWER
button) Turns the TV on or to standby mode.
HDMI 2 IN
