Factory Test & Alignment Specification For MS63F-LA Series (V0.10)
Page 9 of 18
Make sure that Picture Preset is set to
“VIVID
” mode, “
Contrast
” bargraph is set to maximum
(100%) and “
Active BackLight
” is set to “
Off
”.
Ensure that TV is in
Factory mode to access to ”White Balance” adjustment submenu
, then
scroll down to toggle off “
Pic. Enhance
” flag.
PC VGA
,
CMP YPrPb
, R
GB
,
CVBS_PAL Gain/Offset
matrix offsets locations are relative to
HDMI/DTV
.
CVBS_SECAM
and
CVBS_NTSC Gain/Offset
matrix offsets locations are relative to
CVBS_PAL.
Warm
and
Cool
Tone are relatives to
Normal
mode.
¾
“
Gain
” registers set need to be adjusted at 70IRE.
¾
“
Offsets
”
registers set can be adjusted at 30IRE, but it’s not recommended to keep them
defaulted.
Note: All matrix offsets locations can be individually fine-tuned.
Targets and Tolerances for all inputs
The measured parameters should be mainly “
x
”, “
y
” coordinates.
The “
Y
” peak luminance measurement at 100IRE is depending on achievable panel
performance and less important than saturation on high light. If necessary, “
Scaling Contrast
”
register can be adjusted.
The “
BlackLevel
” measurement need to be within
1% ±2
. If necessary, “
Scaling Brightness
”
register can be adjusted.
The White Balance alignment should be performed using a well calibrated and contact less
analyzer (ex: Minolta CA210 or CA310). The analyzer may not touch the screen surface, and
measurement must be performed in a dark environment keeping the probe(s) at 90+/-2° from the
panel center.
The result should fulfill TCL matching specification (Minolta CA310 reference with CH00):
MODEL
COOL(x/y)
NORMAL(x/y)
WARM(x/y)
L32E5300
275/280
280/290
302/307
L42E5300F
270/280
282/297
302/307
L46E5300F
270/280
280/295
302/307
…
…
…
…
within below tolerances:
¾
for Alignment: ± 0.003
¾
for Measurement: ± 0.015
