Test and Alignment Specification for MT5331 Series (v0 91)
Page 5 of 26
Note:
It is necessary to erase Flash before writing code file for reading in correctly EEPROM data
.
Manufacturing Connectors Pinout
VGA
/ P1000
Pin4:RXD Pin11:TXD
USB to UART Bridge Adapter (Silicon Labs CP210 chipset series)
To communicate with TV
product for debugging, adjustment and so… it’s required suitable 0..5V Serial Interface
like following snapshot (further details are described on below sections):
INFO:
All tests and measurements mentioned hereafter have to be carried out at a normal mains voltage (
220 ~ 240
VAC
)
All voltages have to be measured with respect to ground, unless otherwise stated
All final tests have to be done on a complete set including LCD panel in a room with temperature of
25+/-7°C
The Picture Performance assessment such as White Balance (luminance and color temperature) has to be
performed into subdued lighted room after at least
45min
of warm-up in order to avoid any temperature drift
influence (colorimetry vs time)
Summary of Contents for MT31-AP
Page 47: ......
