11
Initial operation
Install the devices of the system completely
Proof the a-, b- and P-wire against each other for short-circuits
V1 and V2 must not be connected with the P-, a- or b-wire
Observe the polarity when connecting the video wires V1 (+) and V2 (−)
Switch on the mains voltage
We are continually improving our products. We recommend to visit our homepage regularly and look for
software updates for your device.
Detailed information on our terms of service for TCS IP-enabled systems you'll find at:
http://www.tcsag.de/fileadmin/user_upload/TCS_DE/Metanavigation/Service_Support/Servicebedingun
gen-IP_uk.pdf.
Settings on the device
Placing the video matching resistor
If the device is installed at the end of a TCS:BUS video
strand, the jumper for the video matching resistor must
be set.
Ex works the video matching resistor is placed in the
position
OFF
.
►
Pull off the jumper (video matching resistor) from the position
OFF
.
►
Place the jumper on the position
ON
(ill. 8).
Fig. 7: Placing the matching resistor
