WCL488 Series Water Cooled Electronic Loads
Operation & Programming Manual
TDI-Dynaload Division
Page 50
402828, Rev. B1
Command and Queries Listed Alphabetically
AV1 <NR2>
Set Amps/Volt pulse base level
AV1?
Read Amps/Volt pulse base setting
AV2 <NR2>
Set Amps/Volt pulse peak level
AV2?
Read Amps/Volt pulse peak setting
AV?
Read Amps/Volt setting
AVH <NR2>
Set Amps/Volt High mode
AVL <NR2>
Set Amps/Volt Low mode
CI <NR2>
Set Constant Current Mode
CI?
Read Constant Current setting
CON?
Read Condition register
CP <NR2>
Set Constant Power mode
CP?
Read Constant Power setting
CR?
Read Constant Resistance setting
CRH <NR2>
Set Constant Resistance High mode
CRL <NR2>
Set Constant Resistance Low mode
CV <NR2>
Set Constant Voltage mode
CV?
Read Constant Voltage setting
DU <NR2>
Set Duty Cycle
DU?
Read Duty Cycle setting
ERR?
Read Error Register
FQ <NR2>
Set Frequency
FQ?
Read Frequency Setting
I?
Read Current
I1 <NR2>
Set Constant Current pulse base level
I1?
Read Constant Current pulse base setting
I2 <NR2>
Set Constant Current pulse peak level
I2?
Read Constant Current pulse peak setting
ID?
Read Identification string
IL <NR2>
Set Current Limit
IL?
Read Current Limit Setting
LAT <NR1>
Set the fault Latch register
LAT?
Read the Latch register setting
LOAD OFF
Open load connect relay
LOAD ON
Close load connect relay