24
83503001 Rev G
1. GENERAL INFORMATION
1.1.
User Manual Content
This User’s Manual contains the operating instructions, installation instructions and
specifications of the Genesys
TM
3300W power supply series. The instructions refer to the
standard power supplies, including the built-in RS232/RS485 serial communication. For
information related to operation with the optional IEEE programming, refer to User Manual
for Power Supply IEEE Programming Interface.
1.2.
Introduction
1.2.1. General Description
Genesys
TM
power supplies are wide output range, high performance switching power
supplies. The Genesys
TM
series is power factor corrected and operates from AC
voltage range of 190-240VAC single phase and three phase for 200V models and 380-
419VAC three phase for 400VAC models. Output Voltage and Current are continuously
displayed and LED indicators show the complete operating status of the power supply.
The Front panel controls allow the user to set the output parameters, the protections
levels (Over-Voltage protection, Under-Voltage limit and Foldback) and preview the
settings. The rear panel includes the necessary connectors to control and monitor the
power supply operation by remote analog signals or by the built-in serial
communication (RS232/RS485). GPIB programming, LXI certified, LAN and Isolated-
Analog programming/monitoring are optional.
1.2.2.
Models Covered by this Manual
Model
Voltage
range (V)
Current
range (A)
GEN 8 - 400
0 - 8
0 - 400
GEN 10 - 330
0 - 10
0 - 330
GEN 15 - 220
0 - 15
0 - 220
GEN 20 - 165
0 - 20
0 - 165
GEN 30 - 110
0 - 30
0 - 110
GEN 40 - 85
0 - 40
0 - 85
GEN 60 - 55
0 - 60
0 - 55
GEN 80 - 42
0 - 80
0 - 42
GEN 100 - 33
0 - 100
0 - 33
GEN 150 - 22
0 - 150
0 - 22
GEN 300 - 11
0 - 300
0 - 11
GEN 600 - 5.5
0 - 600
0 - 5.5
Table 1-1: Models covered by the Manual
1.2.3.
Features and Options
Constant Voltage / Constant Current with automatic crossover.
Active power factor correction.
Single Phase or Three Phase options.
Embedded Microprocessor Controller.
Built-in RS232/485 Interface.
Voltage & Current high resolution adjustment by digital encoders.
High accuracy programming/readback-16 bit.
Software Calibration (no internal trimmers / potentiometers).
Last Setting Memory.
Independent Remote ON/OFF (opto-isolated) and remote Enable/Disable.
Parallel operation (Master/Slave) with Active current sharing.
