83-517-000 Rev.
A
31
5.
Loosen the two chassis screws marked “
A
” halfway.
6. Assemble the enclosure top cover to the chassis and tighten the screws marked
“
A
” (Tightening torque: 4.8 -
5.3 Lb-inch (0.5 - 0.6Nm)).
Figure 3-8 Load Wires Connection to the Output Connector
7. Assemble the enclosure bottom cover
to it’s place, as shown in Figure 3-9,using the screw marked “
C
”,
(Tightening torque 4.8-5.3 Lb-inch (0.5
– 0.6Nm)).
8. Slide down the shutter to secure load wires in place, and tighten the screw marked
“
B
”.
Figure 3-9: Shield Assembly
