6
RISK OF ELECTRIC SHOCK
High Voltage Warning:
Dangerous voltages are present within the power supply
.
To avoid injuries,
always disconnect power, discharge circuits and remove external voltage sources before touching
components.
Class I Warning:
The unit is Class I product. To minimize electrical shock hazard, the unit must be reliably
earthed and professionally installed. Any interruption of the protective ground conductor or disconnection
of the protective earth terminal will cause a potential shock hazard that might cause personal injury.
Energy Hazards Warning:
The main output of the unit is hazardous energy (240VA) and must not be
user accessible in the end application.
Hazardous output Warning:
There is a potential shock hazard when using a power supply with an output
voltage greater than 60VDC. Do not turn ON power supply when output voltage is above 60VDC without
output bus-bars/or output connectors protection assembled. Turn OFF power supply or disconnect power
supply from AC mains before making or changing any rear panel connection.
Internal fuse Caution:
Internal fuse protect the unit and must not be replaced by the user. In case of
internal defect, the unit must be returned to TDK-Lambda Ltd. or one of their authorized agents.
OTHER
The ventilation openings on these products must not be covered. Ensure that there is at least 10cm
spacing between any obstruction and the ventilation openings.
