24
•
Under-Voltage protection setting and readback.
•
Under-Voltage limit setting and read back.
•
Power-supply start up mode (last setting or safe mode).
1.2.4
Analog Voltage Programming and Monitoring
Analog inputs and outputs are provided at the rear panel for analog control of the power supply. The
output voltage and the current limit can be programmed by analog voltage or by resistor, and can
be monitored by analog voltage. The power supply output can be remotely set to On or Off and
analog signals monitor the proper operation of the power supply and the mode of operation
(CV/CC).
1.2.5
Parallel Operation
Up to four
series power supplies of the same output voltage and current rating can be
paralleled in master-slave configuration with automatic current sharing to increase available
power.
1.2.6
Output Connections
Output connections are made to rear panel Connector. Either the positive or negative terminal
may be grounded or the output may be floated. Models up to 100VDC rated output shall not float
outputs more than +/- 200VDC above/below chassis ground. Models above 100VDC rated output
shall not float outputs more than +/- 600VDC above/below chassis ground. Contact factory for
assistance with higher float voltage applications. Local or remote sense may be used.
Warning
If power supply output reaches 60VDC or above, output terminals are hazardous.
WARNUNG
Wenn die Ausgangsspannung 60 VDC oder mehr erreicht, sind die Ausgangsklemmen gefährlich.
1.2.7
Cooling and Mechanical Construction
The
series is cooled by internal fans. At installation, care must be taken to allow free
airflow into the power supply via the front panel, and out of the power supply via the rear panel.
1.3
Accessories
1.3.1
Accessories Provided With the Power Supply
1.3.1.1
Input connector protection for 1.5kW models
•
Strain relief bracket assembly.
•
Strain relief P/N: 5301 5420 by LAPP GROUP.
•
Lock nut P/N: 8211 by AGRO.
1.3.1.2
AC input plug for 1.5kW models
•
P/N: PC 5/ 3-STCL1-7.62 by Phoenix Contact.
1.3.1.3
Output protection cover for models up to 100VDC output
•
Output bus bars cover.
