21405 B Street
Long Beach, MS 39560
Phone: 866.7.TRITON
FAX: 228.575.3101
www.triton.com
3
8.
Configure TDL Gateway Wireless Communications (for wireless only)
•
Select 2, Diagnostics.
•
Select 8, TCP/IP (Wireless).
o
Select 5, Disconnect.
o
Select 1, Signal Strength. For sufficient communications, the signal strength
should be at least 7 or higher. For values less than 7, adjust the location of the
antenna and repeat this step until a sufficient signal strength is achieved.
o
Select 4, Connect. Once a connection is made, an IP address should appear.
•
Select ENTER until you are back at the Main Menu screen, as indicated at the top-left of
the LCD.
9.
Configure VersaLink
®
Communications
•
Select 6, Terminal Configuration.
•
Select 3, Communication.
•
Select 1, Enable VersaSafe Online – Ensure the box is checked.
•
Select 2, Host Address – sckt.versasafe.com. To enter the Host Address, do one of the
following:
o
Connect a USB keyboard to an available USB port on the main board. Type the
Host Password. OR
o
Press the bottom 1x4 key on the right side of the LCD. An electronic keyboard
will come up. Toggling the BLANK key will toggle ALL CAPS. Use the
instructions at the left of the electronic keyboard to type the host address. Select
the CANCEL key to remove the electronic keyboard.
•
Select 3, Host IP Port – 5432.
•
Select 4, Protocol. TCP/IP is for hard-wired Ethernet. TCP/IP (Wireless) is for wireless
connectivity using the TDL Gateway wireless modem. Select the appropriate protocol.
•
Select 9, Test Host Connection.
o
If this step is successful, select ENTER until you exit management functions and
return to the deposit screen.
o
If this step is unsuccessful, review the process for diagnosing communications.
10.
Day Close
Optional – To schedule a day close to close each business day automatically, please perform the
following. Regularly scheduled day closes are recommended in order to denote the conclusion
of a business day.
•
Select 1, Terminal Close Functions.
•
Select 0, Close Options.
o
Select 1, Auto Day Close During Pick-up Close. Ensure the box is checked.
Having this box enabled will aid in balancing the VersaSafe.
o
Select 2, Serial Entry for Bill Acceptor/Pick-up Close. Enable this feature if your
team intends to use serial number tracking for VersaSafe cassettes.
o
Select 3, Schedule Day Close.
Select 1, Enable Schedule. Ensure the box is checked.
