TDR Phoenix Mini, User Manual

Troubleshooting

Problem/Issue

Cause

Solution

Cannot bind drone to 
controller

a) Battery
b) Electromagnetic interference
c) Out of range

a) Make sure the batteries in both drone and 
controller are fully charged
b) Clear out objects between drone and controller
c) Put drone and controller closer to each other

Drone does not turn on

a) Battery too low
b) Battery not fully plugged in

a) Charge battery
b) Reinstall the battery

Controller does not turn on

a) Switch didn't turn on
b) Battery wasn't installed

correctly

c) Battery power too low

a) Ensure switch is turned on
b) Ensure battery fully and correctly plugged
c) Charge the battery

Blades do not spin or 
drone has difficulty taking 
off the ground, LEDs are 
flashing

Battery power level is too low

Fully recharge the battery

Unstable drone flying / 
drifting sideways

Damaged blade(s)

Replace the blade(s)

Gyro off-balance

Recalibrate and trim the drone as necessary

All blades spin but drone 
does not take off the 
ground or not flying 
properly

Blades are not installed correctly

Reinstall the blades following the "Blade 
Installation" section

Drone crashes during 360° 
Flip

Not enough space to perform 
the rolling function

Ensure the drone is at least 9ft from ground and 
9ft away from all other objects in all direction

Drone can not perform 
360° Flip and LEDs are 
flashing

Battery power level is too low

Fully recharge the battery

Cannot take photo or video

Micro SD Card not installed 
correctly or damaged

a) Ensure Micro SD Card is fully inserted
b) Replace Micro SD Card

Blades are not installed correctly Reinstall the blades following the "Blade 

Installation" section