7
ACTIONTEC DSL GATEWAY INSTALLATION
figure 14
figure 13
Wiring for use with up to four computers
(Optional–not supported by TDS Internet
Services Technical Support):
1. Verify each computer meets the system
requirements listed on page 27 of this
User Guide.
2. Purchase an Ethernet cable for each PC.
3. Plug one end of the Ethernet cable into the
Ethernet Network Interface Card (NIC).
4. Plug the remaining end of the Ethernet cable
into one of the yellow Ethernet ports on the
back of the Actiontec DSL Gateway.
5. Repeat these steps for any additional PCs.
Note: Each additional computer must also be
configured. See chapter entitled “Configuring
Your Computer”.
If you have:
Windows XP page 8.
Windows 98, Me, NT or 2000 page 10.
Mac OS X page 11.
Mac OS 8/9 page 12.
