7
Push Here
to detach
an electrical outlet and plug the barrel end of the AC adapter into
the PowerBoot. If the unit is turned off, it will be fully charged in
approximately 12 hours.
Swapping the PowerBoot Module:
The PowerBoot is designed to
be quickly changed (if you purchased additional PowerBoot
Modules). The unit saves enough power that if you swap the
PowerBoot within 30 seconds, it will not trigger a reset. If the saved
power runs out before the new PowerBoot is connected, the unit
will reset. This will not impact saved data, programs or
configuration, however unsaved data will be lost and the time
settings will need to be reset.
To change a PowerBoot Module, perform the following steps:
1. Save your data and turn the unit
OFF
.
2. Remove the hand strap.
3. Unlock the latches on both PowerBoot Modules. Use a
screwdriver or the flat head of the supplied stylus to turn the
latches counter-clockwise until arrows point downward towards
the I/O ports on the PowerBoot.
4. With the unit upside down, remove
the PowerBoot by using your thumbs
to push and slide it away from the unit
as shown in the illustration. Be careful
to not press the
Power
key while the
PowerBoot is detached.
5. Quickly slide the new PowerBoot onto the unit.
6. Lock the latches on the new PowerBoot by turning them
clockwise one half turn until the arrows on the latches point
away from the I/O ports.
7. Replace the hand strap.
8. Turn on the unit to resume operation.
Accessing Storage Memory using File Explorer
File Explorer (
Start / Programs / File Explorer
) lets you browse
the contents of folders on your unit. To easily delete, rename, or
copy an item, touch and hold the item.
NOTE: Unlike PCs, Windows Mobile
®
6.0 does not support a
Recycle Bin. Once a file is deleted, it cannot be recovered.
