Slowly push
fi
ber through hole until the end appears among the wires on the other side of
the ACO32.
Using a pair of tweezers, carefully pull the end of the
fi
ber and insert it into the hole next to
the encoder.
Pull the end of the
fi
ber through the hole and insert it through the hole in the groove of the
connector module.
Leave enough slack in the section of
fi
ber between the encoder and connector modules to
match the loop of the other wires. A small lightweight tie can be loosely attached to hold the
fi
ber adjacent to the wires.
2.
3.
4.
5.
ACO32/ACO64 Motorized Commutators | 11
