Connect the FC/PC connector end of the
fi
ber to (the smaller section of) the
fi
ber optic
rotary joint.
Slowly pull all of the excess
fi
ber through the ACO32 until the FC/PC connector is inside the
ACO32 and the
fi
ber optic rotary joint plate can be attached to the ACO32 plate.
Attach the encoder clamping plates back onto the ACO32 shaft by tightening the two
screws.
The plate should be just below body of the ACO32 and the encoder body should sit snuggly
inside the lip of the clamping plates. Be careful not to pinch any wires or the
fi
ber as the
plates are tightened together.
6
.
7.
8
.
ACO32/ACO64 Motorized Commutators | 12
