Accessing RS4 Storage
Data stored on the RS4 can be easily reincorporated into the TTank data format for post
processing.
RS4 v2.x and 3.x devices
Enter the device name or IP address as shown in a windows address bar to access the RS4
fi
le
system.
Access RS4
fi
le system in Windows Explorer
RS4 v1.x devices
The older RS4 devices use SMB 1.0 protocol, which is no longer supported by default in
Windows 10. See
for more information.
For a more secure
fi
le transfer between the RS4 v1.x and Windows 10, use WinSCP.
WinSCP Setup
On the RS4, go to the Con
fi
g -> Settings and make sure SFTP Data Access is set to 'Yes'.
On Windows, download and install
Launch WinSCP and set:
File protocol is
SFTP
Host name is your
RS4 IP address
Before starting a new recording session, make sure the RS4 has stopped the previous session and the ports are
Idle. Switching too quickly may cause the new data to be appended to the previous session data, or there could be
a gap in the beginning of the new session data. This gap will be showing in the RS4 log
fi
le saved next to your
data
fi
les. See
.
Important
1.
2.
3.
•
•
RS4 Data Streamer | 17