Naming Convention
When connected to an active network, TDT's Synapse software sends information to the RS4
via a broadcast UDP packet allowing it to properly name the streaming data sent to the RS4.
For example, if you are recording channel 1 for the event wavA on Block-3 from DemoTank2
the RS4 will store in the following location and format:
\data\DemoTank2\Block-3\DemoTank-Block-3_wavA_ch1.sev
Without the Synapse network information the RS4 falls back to the default data format:
\data\EventName-Year-Month-Day-Hour-Minute-Second\Unnamed_ch1.sev
To move blocks to a Data Tank:
Access the RS4
fi
le system on the local PC using the process described above in
.
Select the desired Data Tank.
Copy the selected Data Tank to the local PC Data Tank.
If the Data Tanks share the same name, select
Yes to All
when asked to con
fi
rm possible
merged folders. This will
not
overwrite data currently stored on the local drive since only the
*.sev
fi
les and RS4 log
fi
les are copied.
The default format is also used if Phantom Storage and Send Renaming Packet are disabled in the
Note
1.
2.
3.
4.
RS4 Data Streamer | 20