408-32142
Rev B
2
of 2
7. Discard the cage assembly. It is not designed to be reused.
8. Check the pc board for damage to cage mounting holes, surface traces, and components.
Figure 2
5.
MAINTENANCE AND INSPECTION
TE Connectivity recommends that the tool be inspected immediately upon its arrival to ensure that it has not
been damaged during shipment.
5.1.
Daily Maintenance
It is recommended that each operator be made aware of, and responsible for, the following steps of daily
maintenance:
Remove dust, moisture, and other contaminants with a clean, soft brush, or lint-free cloth. DO NOT use
objects that could damage the tool or any of its components.
When the tool is not in use, store it in a clean, dry area.
5.2.
Periodic Inspection
Regular inspections should be performed by quality control personnel. A record of scheduled inspections
should remain with the tool or be supplied to personnel responsible for the tool. The inspection frequency
should be based on the amount of use, working conditions, operator training and skill, and established
company standards.
6.
REPLACEMENT AND REPAIR
Order tools through your TE Representative, or call 1-800-526-5142, or send a facsimile of your purchase order
to 717-986-7605. or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
7.
REVISION SUMMARY
Added NOTE to Paragraph 4.2
