408-9968
Rev
A
4
of 4
5. Push the disconnect assembly on to the jumper stud and release hot stick enough to disengage the
stabilizing ribs. Turn the eyebolt clockwise to apply a torque of 22 Nm [16 ft. lbs]. See Figure 6.
Figure 6
6. Figure 7, Illustrates optional configuration.
Figure 7
5.
TOOL RETURN OR REPLACEMENT
Order tools through your TE Representative, or call 1-800-327-6996, or send a facsimile of your purchase order
to 514-671-1525 or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
In Canada, write to:
TYCO ELECTRONICS CANADA ULC
20 ESNA PARK DR.
MARKHAM, ONTARIO
CANADA L3R 1E1
6.
REVISION SUMMARY
Updated document to corporate requirements
Changed text in title and Section 1
– INTRODUCTION
Added new table in Figure 2 and CAUTION note to Paragraph 4.1.3
Updated text in Section 5
Stabilizer Ribs
Disengaged
from Hot Stick
Hot Stick
Eyebolt
Hot Stick
Clockwise
Disconnect Pigtail
Connector
Hot Stick
“C”
Jumper Stud
Optional Configuration
