114-151049
Rev A
8
of 11
3.9. Connector Unmating
To unmate the plug and receptacle, use a M4 hex tool turn the jackscrew bolt counterclockwise until
completely unmated. Separate plug from receptacle.
Caution:
Be careful not to damage the plug interface sea. Replace if necessary.
3.10. Printed Circuit Board Mounting
Solder the header to the PCB then secure the DRC13 header using M3 [4-40] hardware. Mounting
hardware (i.e. screw, washer, nut) are customer supplied. Screw length depend on application. DRC10
does not require mounting hardware.
Note:
1)
Mounting torque not to damage connector or PCB.
M4 Hex Tool
PCB
Screw
Nut
Washer
PCB
Jackscrew Bolt
with M4 Hex
