HT40 Basic Hand Tool
Page 6 - 7
Operating instructions
411-18589-1 Rev.A
Insert the crimping head into the hand tool basic body again.
Press the locking pins until the stop.
4.2
Removing dies
Open the tool grip and check that the movable die holder is completely retracted.
Pull both locking pins out until the stop.
Remove the crimping head.
Remove both crimping dies.
Insert the crimping head into the hand tool basic body again.
Press the locking pins until the stop.
5
Operation
5.1
Crimping terminals
This process can be taken from the operating manual of the corresponding crimping die.
5.2
Fast feed
It is possible to drive the movable die holder more quickly into the position that you require us-
ing the fast feed lever. Only one further step is needed for this.
Rotate the fast feed lever anticlockwise until you have reached the position that you re-
quire.
5.3
Early release
If a release of the hand tool must be carried out, this is possible in a few steps. Depending on
the progress of the crimping or the extent of the hand tool loading, two situations are possible:
Situation 1: Very low or no loading of the hand tool
Press the releasing lever downwards and keep this pressed.
Rotate the fast feed lever clockwise until the movable die holder is in the initial position.
Situation 2: High loading of the hand tool
Press the releasing lever downwards and keep this pressed.
Position the combination spanner on the releasing pin on the back side.
Now rotate this anticlockwise until the movable die holder is in the initial position.
NOTE
Do not use the terminal in the case of early release!
NOTE
Do not use the terminal in the case of early release!
