409-35011
Rev C
34
of 54
CAUTION
If you change the size of your tooling, you must change the article to match the tooling you want to calibrate. Otherwise, the
machine will measure against the last selected article and will give you an error because the new tooling does not match the
old article cable size.
d.
When you select the Calibration button, the machine will perform the procedure and check against
the currently selected article (see Figure 35).
Advanced parameters
1. If it is necessary to make additional adjustments after all adjustments in the standard setup mode
have been attempted, there is an advanced parameters option. The parameters that can be edited for
each step in the process will show as that step is highlighted in the list on the left of the screen. For
values that require a numerical input, the keyboard will show the description, default value, current
value, and allowable value range will show on the top-left of the keyboard (see Figure 36).
Figure 36
CAUTION
It is always possible that some of the scrap may get stuck in the machine or scrap tube, especially when testing a new cycle. It
is important to stop the cycle, perform LOTO, and then clear the scrap from the machine area, the blades, or the scrap tube to
ensure nothing jams or causes damage to the blades, wheels, or cutting arms.
Advanced Options
Article Status
Machine Status