409-35011
Rev C
2
of 54
SAFETY PRECAUTIONS
—
AVOID INJURY
—
READ THIS FIRST!
Safeguards are designed into this application equipment to protect operators and maintenance personnel from
most hazards during equipment operation. However, certain safety p
r
ecautions must be taken by the operator
and repair personnel to avoid personal injury, as well as damage to the equipment. For best results, application
equipment must be operated in a dry, dust-free environment. Do not operate equipment in a gaseous or
hazardous environment.
Carefully observe the following safety precautions before and during operation of the equipment:
Always wear approved eye and ear protection while
operating equipment.
Moving parts can crush and cut. Always keep guard(s)
in place during normal operation.
Always ensure customer-provided power supply is
grounded to avoid electrical shock.
Electrical shock hazard.
Always turn off the main power switch and disconnect
the power source when performing repair or
maintenance on the equipment.
Lock out electrical power when performing repair or
maintenance on the equipment
Lock out air supply when performing maintenance or
repair on this equipment.
Ensure that guards are in place and secure to
equipment.
Do not operate the equipment without guards in place.
Always disconnect air supply and then exhaust system
air pressure before performing maintenance or repair
on the equipment.
Use caution when working with this equipment.
Never insert hands into installed equipment.
Never wear loose clothing or jewelry that may catch in
moving parts of the equipment.
Never alter, modify, or misuse the equipment.
Never use the machine for other than what it is
designed.
Never look directly into the internal machine light.
Bright light can damage the eye.
Never enter the electrical enclosure immediately after
turning OFF the machine power switch and
disconnecting the electrical power source. High voltage
electrical energy may be present in the electrical
enclosure. Read the warning label on the electrical
enclosure door before entering the system.
Pressure Release.
Caution
–
System may be pressurized.
IMPORTANT SAFETY INFORMATION
NOTE
Keep all decals clean and legible and replace them
when necessary.
DANGER
FIRE HAZARD
Do not use solvents or flammable liquids to clean the
machine. Solvents or flammable liquids could ignite and
cause serious injury or property damage.
CAUTION
Do not perform any service or maintenance other than
as described in this manual. Injury or damage to the
machine may result. Failure to observe these
precautions may result in injury or property damage.