409-35011
Rev C
22
of 54
Tooling
Instructions for a tooling change-over (different cable) or tooling replacement (worn or broken tooling) is
presented in Section 6.3. Cutting wheels, contour blades, and mandrels are wear items.
Customers
should order several sets of tooling and keep them on hand at all times.
Use Figure 23 to properly understand and choose the correct tooling from the table in Figure 24.
Figure 23
Cable
Size
(AWG)
Cable
Size
(mm²)
Outer
Diameter
(mm)
Core
Diameter
(mm)
Manual
Over-ride
(mm)
Conductor
Diameter
(mm)
Mandrel
Contour
Blade
Kit *
Cutting
Wheel
Kit **
8
10
8.8 (-0.6)
6.0 (-0.6)
-
4.5
2360456-1
2364113-1
2364114-1
6
16
10.2 (-0.6)
7.2 (-0.6)
-
5.8
2360456-2
2364113-2
4
25
12.2 (-0.6)
8.8 (-0.6)
-
7.2
2360456-3
2364113-3
2
35
14.4 (-0.6)
10.5 (-0.7)
-
8.5
2360456-4
2364113-4
1
50
15.8 (-0.6)
12.1 (-0.7)
12.09 - 12.20
10.5
2360456-5
2364113-5
0
60
16.9 (-0.6)
13.0 (-1.2)
12.99 - 13.30
11.6
2360456-6
2364113-6
00
70
18.2 (-0.8)
14.4 (-1.4)
-
12.5
2360456-7
2364113-7
000
95
20.9 (-0.8)
17.2 (-1.4)
-
14.8
2360456-8
2364113-8
0000
120
23.0 (-0.8)
19.0 (-1.4)
-
16.5
2360456-9
2364113-9
*
Contains 3 cutting blades
**
Contains 3 cutting wheels
Figure 24
NOTE
Figure 24 describes the correct tooling needed for the cable sizes listed. The Manual Over-ride column only applies to two of
these sizes as shown above. Due to variances in cable brands, some cable sizes may have overlapping Core Diameters. In
this case the operator may need to manually select the appropriate tooling. The ranges displayed in the Manual Over-ride
column show the possible overlapping ranges.
