114-13233
Rev B
6
of 13
3.10.
Installation of Backshell Assembly
(See Figure 5)
Place one side of the backshell on the back of the connector aligning the rib on the housing with the
groove in the backshell. Make sure that the backshell is on top of the last gland of the sealing boot/plug.
NOTE
Make sure the screw threads are recessed into the strain relief clamp to prevent interference with the housing during
assembly.
Repeat step 1 with the other half of the strain relief clamp.
Using a 5/64-in. Allen wrench, tighten the captive screws.
Apply two cable ties through the backshell as shown.
Figure 5
Captive Screws
Recessed for
Assembly
Seal Gland
Under Backshell
Backshell
Retention Rib
Cable Ties (Customer Supplied)
Captive Screws Thread
into Housing
Retention Rib in
Backshell Groove
