Raychem Devices
No: RCPS-200-20
Rev: E1
Date: August 10, 2016
Installation Procedures for D-436-XX and D-200-XX
(Miniseal™) Sealed Crimp Splices
_________________________________________
Unless otherwise specified dimensions are in millimeters. [Inches dimensions are in between brackets]
© 2007-2016 TE Connectivity Corporation. All rights reserved.
If this document is printed it becomes uncontrolled. Check for the latest revision.
both stub and in-line splices. Some of the parts in the D-436 and D-200 series consist of
sealing sleeves only. Parts are supplied in three basic configurations, according to the
number of wires that can be spliced together. These part and splice configurations are as
follows:
4.1.1
One-Wire to One-Wire In-Line Splices, or Two-Wire Stub Splices.
Parts for each splice are:
(1) One crimp splice.
(2) One sealing sleeve with two integral one-hole seals (shown).
4.1.2
Multiple-Wire to One-Wire In-Line Splices, or Multiple-Wire Stub Splices.
Parts for each splice are:
(1) One crimp splice.
(2) One sealing sleeve with one integral one-hole seal and one integral multiple-hole seal
(shown).
4.1.3
Multiple-Wire to Multiple-Wire In-Line Splices.
Parts for each splice are:
(1) One crimp splice.
(2) One sealing sleeve with one integral multiple-hole seal and one separate multiple-hole
seal (shown).
