9
INSTALLING THE BATTERY
See illustration IV
Please install the provided lithium battery correctly as shown in illustration IV:
1.
Switch and hold the Battery Cover Switch (11) upwards to release the
battery cover.
2.
Simultaneously slide the battery cover to the right to release and remove it.
3.
Place the battery inside the battery compartment. Make sure the
electrodes of the battery correspond to the symbols on the cover.
4.
Slide the battery cover back in place and switch the Battery Cover Switch
(11) downwards to lock the battery.
5.
CHARGING THE BATTERY
1.
Make sure the battery is installed.
2.
Make sure the Guardo Action Cam is
turned off.
3.
Connect the micro USB cable (13) to the Micro USB Port (8)of the Guardo Action Cam.
4.
Connect the other end of the micro USB cable(13 to the USB port of your computer or
the optional Guardo USB home charging device, optionally available on www.guardo.be.
5.
The camera will be turned
21
automatically (PCU or CAR will be displayed), and starts
UHFRUGLQJZKHQȟ&$5ȠLVˊDVKLQJ6WRSUHFRUGLQJE\SUHVVLQJWKH5HFRUG%XWWRQ
6.
During charging, the blue LED Indicator (12) will light continuously.
When charging is completed the blue LED Indicator (12) will turn off.
Note:
x
The camera can be used while charging.
x
When the battery runs out of power, the Guardo will turn off but will save the part that was
recorded until the camera turned off.
x
When the camera is ON but not in use it will automatically turn off after 5 min.
x
:KHQWKHEOXH/('LQGLFDWRUZLOOˊDVKLQVWHDGRIOLJKWFRQWLQXRXVO\WKLVPHDQVWKDW
there is no battery inside the camera.
x
Extra batteries and charging devices/accessories can be ordered from our website:
www.guardo.be
USE
(11)
