TE Energy 2510B, User'S Operating Instruction And Installation Manual

Energy 2510 B 

Vers. 001

GB

18 

Fuel is fed to the internal combustion engine via 
a pump fitted to the generating set as part of the 
standard supply. 
 

5.1 Machine 

safety 

The generating sets come with perfectly sealed 
casings, so there is no danger of contact with any 
moving or high temperature parts or with live 
cables. 
The doors open with a lock and key. The keys 
must not be left within the reach of children or 
inexperienced persons. 
 

The generating sets 

must only and exclusively be used with their 
doors shut. 
Remove any flammable substance (for 
example: petrol, paints, solvents, etc.) from 
near the generating sets. 
Make sure that any hot parts of the 
generating sets are not in contact with any 
flammable material. 
Never fill up the fuel tank while the engine is 
running. 
Never touch the generating sets or the wiring 
connections with wet hands. 
Never replace the fuses or the cut-out 
switches with others having higher 
amperage. 
Should any electrical part need checking, this 
must only be done with the engine turned off 
and by specialised personnel.

 
The generating sets have been built in 
compliance with the safety standards listed in the 
EEC statement of compliance. 
 

 
6   USING THE GENERATING SET 

6.1  Starting up the generating set 
 

The generating sets are provided with an 
electronic remote control panel which allows you 
to perform starting up / turning off operations and 
to check their running conditions. 
The panel controls are: 
 
1 ON/OFF 

switch 

2 Display 

unit 

3  High temperature indicator 
4  Engine minimum oil level indicator 
5  Startup failed  
6  Generator running (flashing) 

7  Engine oil change indicator 
8  Fuel warning light 
9  Display time changeover switch 
10 Reset 
 
Set the startup switch (Fig.30 Ref.1) to its “

ON

” 

position. The message “WAIT” will be displayed 
for 8 seconds. After this time, the electronic 
control panel will start the first automatic 
procedure for starting up the generating set. If 
the engine starts up at the end of this phase, the 
“generator running” indicator light (Fig.30 Ref.6) 
will start to flash. 
Should the engine not start up, this automatic 
procedure will be repeated up to 4 times. 
If, at the end of a complete cycle, the engine has 
not yet started up, the “startup failed” indicator 
(Fig.30 Ref.5) will light up to signify that the 
generating set has failed to start up. 
If the “startup failed” indicator (Fig.30 Ref.5) light 
only stays lit, you can repeat the procedure 
several times. 
 

 
 
 
If the generating set has not started up after 
several attempts, contact the manufacturer’s 
After-sales service. 
Should the battery be flat, you can start the 
generating set by hand, using the handle of the 
engine coil winding (Fig.31 Ref.1) after setting 
the selector switch to "ON" (Fig.31 Ref. 2) and 
the electronic control panel to "ON". 
Once you have started up the engine manually, 
put the selector switch back to "0FF" (Fig.31 Ref. 
2). The start-up battery should never be 
disconnected, as there would be no input to the 
electronic control panel which would prevent the 
generating set from working.