TE Energy 2510B, User'S Operating Instruction And Installation Manual

Vers. 001

Energy 2510 B

GB

21

the electronic control panel will turn off the 
generating set.

 Setting the switch to the 

automatic position after turning the control panel 
on sets the generating set in stand-by mode and 
does NOT activate the automatic function. 
 
 

Remember that the time which is taken by 
the generating set in automatic mode to 
recharge the battery may vary according to 
the battery status, the amount of connected 
batteries and the season temperature. 
Generally, the lower the temperature the less 
the time required to charge the battery. 

Applying any load higher 

than the energy just then available in the 
battery will prevent the generating set from 
turning on due to insufficient voltage

. 

7   MAINTENANCE INSTRUCTIONS 

Only use original spare 

parts. Using poorer quality spare parts may 
damage your generating set. 
Routine checks and adjustments are of the 
essence in preserving a high level of 
performance. Routine maintenance also 
ensures long generating set life. 
 

Before performing any 

check or maintenance operation on the 
generating set, turn the selector switch (Fig. 
31 Ref.2) to the position 1 “manual” in order 
to avoid accidentally starting up the 
generating set. 
 
 
7.1  Service check list 

 
See table at the bottom of page 25. 
 
 

7.2   Maintenance not requiring specialised 
personnel

To perform this kind of service, it will be 
necessary to open the generating set door. The 
following precautions must therefore be taken: 
1  The generating set must not be in operation, 

and all its parts must be cold 

2  Let the generating set cool off. 
3  Turn the selector switch to the position "ON" 
(manual) (Fig.31 Ref.2) 
 

N.B. Remember to switch the selector switch 
to "OFF" (automatic) after completing the 
required checks. 

7.3   Checking the engine oil level 
 

•

Unscrew the engine oil filler cap and clean the 
dipstick (Fig.33 Ref.1). 

•

Put the dipstick back in without screwing. 

•

Take the dipstick out again, and make sure 
that the engine oil level is between the two 
(min and max) notches. Should the oil level be 
below the minimum notch, restore the oil level 
using the recommended type of engine oil 
(refer to the engine user and maintenance 
manual). 

•

Put the dipstick and filler cap back on and 
screw tightly. 

•

Do not fill to exceed the 

maximum level, as this could cause 
malfunctioning of the fuel pump and hence of 
the generating set.