LVM-110 SIGNAL CONDITIONER
With DC Voltage Output
TE CONNECTIVITY SENSORS
/// LIM-420
MANUAL 09290051-000 REV C
07/2016
Page 4
Product Description
This device is compatible with most, but NOT all, 5 and 6 wire LVDT and RVDT type transducers. Please consult the product
specification to ensure compatibility with your particular sensor.
DIP switches are provided to allow selection of four transducer excitation frequencies, from 2.5 to 10 kHz. Switches are also
provided to select six coarse gain ranges, two zero offsets, and master/slave or standalone operation.
Installation may be accomplished by use of the card-edge connector or threaded stand-offs and screw-lock barrier strip
connections.
The next few pages will take you, step by step, through the simple set-up and calibration process. This device may be set-up for
several different full scale analog outputs; some of the potential configurations are listed below:
±10 VDC output
±5 VDC output
0 to 10 VDC output
Standalone operation
Master/slave operation
Circuit Top View
Connection Diagram
