LVM-110 SIGNAL CONDITIONER
With DC Voltage Output
TE CONNECTIVITY SENSORS
/// LIM-420
MANUAL 09290051-000 REV C
07/2016
Page 7
Zero Suppression Calibration (for 0 to 10 VDC Output)
To perform a 0 to 10 VDC calibration, follow the instructions for the ±5 VDC calibration, then displace the LVDT core or the
RVDT shaft to the minus full scale position (-5VDC output between pins 9 and 10). Using the table below, select a
+4 Volt offset
:
S2-C
S2-D
Offset
OFF
OFF
None
ON
OFF
-4VDC
OFF
ON
+4VDC
After zero switches are set, the output at the minus full scale position should have changed to
–
1VDC approximately.
Using the ZERO potentiometer, adjust the DC output until it changes to zero VDC, from the original -1VDC. Return to the original
zero (mid) position; you should now read +5 Volts DC instead of zero. Continue in the same direction up to the original positive
full scale position; the reading should be +10 VDC. The output was shifted by +5VDC; your calibration is now complete for a 0
to 10VDC output range.
Other custom DC output ranges can be achieved by using different ZERO potentiometer adjustments and/or offset switch
settings.
NORTH AMERICA
EUROPE
ASIA
Measurement Specialties, Inc.,
a TE Connectivity Company
1000 Lucas Way
Hampton, VA 23666
United States
Phone: +1-800-745-8008
Fax: +1-757-766-4297
Email: customercare.hmpt@te.com
MEAS Deutschland GmbH
a TE Connectivity Company
Hauert 13
D-44227 Dortmund
Germany
Phone: +49-(0)231-9740-0
Fax: +49-(0)231-9740-20
Email: customercare.dtmd@te.com
Measurement Specialties China Ltd.,
a TE Connectivity Company
No. 26, Langshan Road
High-tech Park (North)
Nanshan District, Shenzhen 518057
China
Phone: +86-755-33305088
Fax: +86-755-33305099
Email: customercare.shzn@te.com
te.com/sensorsolutions
Measurement Specialties, Inc., a TE Connectivity company.
Measurement Specialties (MEAS), American Sensor Technologies (AST), TE Connectivity, TE Connectivity (logo) and EVERY CONNECTION COUNTS are trademarks. All other logos,
products and/or company names referred to herein might be trademarks of their respective owners.
The information given herein, including drawings, illustrations and schematics which are intended for illustration purposes only, is believed to be reliable. However, TE Connectivity makes
no warranties as to its accuracy or completeness and disclaims any liability in connection with its use. TE Connectivity‘s obligations shall only be as set forth in TE Connectivity‘s Standard
Terms and Conditions of Sale for this product and in no case will TE Connectivity be liable for any incidental, indirect or consequential damages arising out of the sale, resale, use or misuse
of the product. Users of TE Connectivity products should make their own evaluation to determine the suitability of each such product for the specific application.
© 2016 TE Connectivity Ltd. family of companies All Rights Reserved.
