33
ENGLISH
4.2 Connecting the PCMCIA card to a Notebook-PC
To be able to use the PCMCIA card with your notebook computer you
have to activate the PCMCIA system of your notebook and you must
install any neccessary driver in accordance to the manuals of your
operating system and your computing platform.
Important:
Normally the installation of the drivers and the activating of the
PCMCIA system is carried out without inserting the PCMCIA
card into the respective slot. Please refer to your manual of
DOS/Windows and your hardware platform for further details.
Insert the PCMCIA card connected to the TEAC CD-224PE into the
respective slot of your notebook after completing the software installa-
tion (PCMCIA system, card drivers etc.). The golden contact pins must
be oriented towards top to achieve this operation.
Important:
Please follow the following instructions for each of the operating
systems in question carefully. To insert/remove the card the note-
book computer usually has to be switched off. Only Windows
95/98 allows under some certain circumstances depending on
the PCMCIA cards firmware to remove/insert the card while run-
ning the computer. Please refer to the manuals of your operat-
ing system and your computing platform.
4. Installation