Teac CD-C68E, User Manual

    4.6  Notes When Using

     (1) Auto setting

           Windows95’s “Auto Insert Notification”, “Auto Run” and “Auto Play” automatically execute the specified

          operations when a disc is loaded or unloaded.  However, with some CDs - especially music CDs - are

          used, the disc may be switched unnecessarily.  To prevent this, the auto settings are automatically

          disabled when the TEAC device driver is installed in the multi-drive mode. To enable these functions,

          use the Changer Assistance Utility.

           When it is installed in the signal drive mode, the number of disc changes in the drive can be decreased

          even when all automatic settings are enabled.

      Note: To decrease the number of disc changes when the Auto Insert Notification is enabled in the multi-

               drive mode, do not insert a disc in the arbitrary slot until it is required.  This method can be also

               used to shorten the start-up time of the microcomputer.

     (2) MCICDA DRV

          When CDP is installed in Windows 3.1, the SYSTEM.INI (normally located in the directory in which

          Windows is installed) is changed as shown below to allow playback in all slots.

          Before change :  CDAudio   = MCICDA.DRV

          After change    : CDAudio   = MCICDA.DRV0

                                   CDAudio1 = MCICDA.DRV1

                                   CDAudio2 = MCICDA.DRV2

                                   CDAudio3 = MCICDA.DRV3

                                   CDAudio4 = MCICDA.DRV4

                                   CDAudio5 = MCICDA.DRV5

          If you have any operational problems after installation, restore the setting before changing.

     (3) Changer Assistance Utility

          The Changer Assistance Utility lets you edit various registry key data.

          Do not forcibly interrupt key data editing (e.g. reset) as this may delete the registry.  Be sure to

          back up the registry before editing the data.

          We are not responsible for inadvertent loss or destruction of the registry caused by executing this

          utility or for any errors which make restart impossible.

     (4) Drive letter

          If the device driver is not installed properly, only one drive letter may be displayed even in the multi

          -drive mode.  In this case, click System in the control panel to check the property in the device

          manager(hard disc controller).

          Also, if the changer drive is used in a system which users (or has used) a CD-R drive, only one drive

          letter may be displayed even in the multi-drive mode.  Contact your CD drive manufacturer or dealer

          if you have any problems.

     (5) Enhanced CD

          Most enhanced CDs such as CD-Extra are not designed with changers in mind. As a result, these

          types of CDs may not operate normally in the changer drive.  For best results, always be sure to insert

         enhanced CDs in Slot 1. If you still have problems, contact your CD manufacturer or dealer.