46
Funcionamiento básico (1)
1
Pulse el interruptor POWER para encender (on) la unidad.
<
La reproducción empezará automáticamente si ya hay un disco
insertado.
2
Pulse el botón OPEN/CLOSE (
L
) para abrir la bandeja.
3
Coloque un disco en la bandeja con el lado de la etiqueta
hacia arriba.
<
Nunca coloque más de un disco en la bandeja.
<
El disco debe estar centrado en la bandeja. Si no se carga
correctamente el disco, podría no abrirse la bandeja después
de cerrarla. Confirme que el disco está siempre centrado en la
bandeja antes de cerrarla.
<
No haga fuerza en la bandeja con la mano ni al abrirla ni al
cerrarla.
4
Pulse el botón OPEN/CLOSE (
L
) para cerrar la bandeja.
<
Depués de cerrar la bandeja, la carga del disco lleva unos
cuantos segundos. Ningún botón funcionará mientras dure la
carga. Espere hasta que en pantalla aparezca el número total de
pistas/archivos.
<
Cuando no hay ningún disco cargado en el reproductor de CDs,
en la pantalla aparece “
”.
Cuando se carga un CD de audio
Cuando se carga un disco MP3
5
Pulse el botón de Reproducción/Pausa (
y
/
J
) para
comenzar la reproducción.
La reproducción empieza desde la primera pista/archivo del
disco.
<
Los archivos MP3 que no están en carpetas son colocados
automáticamente en la carpeta “ROOT” (directorio raíz). La
reproducción empieza desde el primer archivo de la carpeta raíz
“ROOT”.
<
Cuando la reproducción de todas las pistas/archivos haya
terminado, la unidad se detendrá automáticamente.
<
Ver página 57 para más información sobre el orden de
reproducción de los discos MP3.
Pistas totales
Tiempo total de
reproducción
Número total de carpetas
Número total de archivos