5
EN
G
LI
SH
Caution:
<
Turn off the power of all the equipment before making
connections.
<
Read the instructions of each component that you intend to use
with this unit.
<
Be sure to insert each plug securely. To prevent hum and noise, do
not bundle connection cords with power cords.
A
LINE OUT jacks
An analog 2-channel audio signal is output from these jacks.
Connect it to the CD input jacks of an amplifier with RCA cables.
Be sure to connect:
White plug
q
White jack
(L: left channel)
Red plug
q
Red jack
(R: right channel)
B
AC Power Cord
After all other connections are complete, connect the plug to an
AC wall outlet.
Be sure to connect the power cord to an AC outlet that supplies
the correct voltage.
Hold the power plug when plugging or unplugging the power
cord. Never pull or yank on the power cord.
Voltage Selection
Be sure to remove the power cord from the AC outlet before changing
the position of the voltage selector switch.
1. Locate the VOLTAGE SELECTOR switch on the rear panel.
2. Using a flat-bladed screwdriver, set to the appropriate position
(230 V or 120 V) for the power supply used in your area.
IN NORTH AMERICA USE ONLY ON 120 V SUPPLY.
Amplifier
Connections
Remote Control Unit
The included remote control allows this unit to be operated from a
distance.
When using the remote control, point it towards the remote sensor on
the front panel of the main unit.
<
Even if the remote control unit is used within its effective range,
operation by remote control might be impossible if there are any
obstacles between the unit and the remote control.
<
If the remote control unit is operated near other devices that
generate infrared rays, or if other remote controls that use infrared
rays are operated near the unit, this unit might operate incorrectly.
The other devices might also operate incorrectly.
Battery Installation
1. Remove the battery compartment cover.
2. Insert two AA (R6 or SUM-3) dry batteries. Make sure that they are
inserted with their positive (
+
) and negative (
_
) poles oriented
correctly.
3. Close the cover.
Battery Replacement
If the distance from the main unit that the remote control works
effectively decreases, the batteries are probably exhausted. Replace
the batteries with new ones when this happens.
For more information about the collection of batteries, please contact
your local municipality, your waste disposal service or the place where
you purchased them.
Precautions concerning batteries
<
Be sure to insert the batteries with correct positive (
+
) and
negative (
_
) orientations.
<
Use batteries of the same type. Never use different types of
batteries together.
<
Both rechargeable and non-rechargeable batteries can be used.
Refer to the precautions on their labels.
<
If the remote control will not be used for a long time (more than a
month), remove the batteries to prevent them from leaking.
<
If the batteries leak, wipe away the leakage inside the battery
compartment and replace the batteries with new ones.
<
Do not use batteries of types other than those specified. Do not
mix new batteries with old ones or use different types of batteries
together.
<
Do not heat or disassemble batteries. Never throw batteries into
fire or water.
<
Do not carry or store batteries with other metallic objects. The
batteries could short circuit, leak or explode.
<
Never recharge a battery unless it is confirmed to be a rechargeable
type.
