Rear Panel
TEAC CD-RW Installation Guide
3
Rear Panel
analog audio output connector:
You can use an audio cable to connect this
connector to the audio input connector on a sound card. Pin assignments are
described below:
jumper pin configuration jumper:
The CD-RW drive includes seven pairs of
jumper pins on the rear panel that allow you to set the SCSI ID number,
termination, and parity.
interface connector:
Use a standard 50-pin SCSI interface cable to connect the
CD-RW drive to a SCSI interface adapter card installed in your computer.
power connector:
Connect the power connector to the +5VDC and +12VDC
power sources. The +5VDC terminal is on the left as you face the rear panel; the
+12VDC terminal is on the right. The two center terminals are ground terminals.
FG:
Frame ground. This is a ground connection for the CD-RW Drive.
Pin Number
Audio Signal
1
Left signal
2
Ground
3
Ground
4
Right signal
▼
INTERFACE CONNECTOR
SCSI
jumper pin
interface
connector
power
connector
frame
ground
configuration block
analog audio
connector
CD-W512Sshort.fm Page 3 Thursday, December 14, 2000 10:30 AM
