Installing the CD-RW Drive
TEAC CD-RW Installation Guide
6
5.
Connect the CD-RW drive to the SCSI host adapter card using a 50-pin
interface ribbon cable.
Be certain to connect pin 1 on the CD-RW drive to pin 1 on the SCSI adapter
card. (Pin 1 on the interface cable is usually designated by a color stripe along
one edge of the cable. Also, the interface ribbon cable connector may feature a
tab on one side. Insert the cable so that the tab aligns with the notch in the
interface connector.)
Connect the opposite end of the interface ribbon cable to the interface connector
on the rear panel of the CD-RW drive.
6.
If desired, connect an audio cable to the analog audio connector on the
rear panel of the CD-RW drive and connect the opposite end to your sound
card.
Connect audio connector pin 1 on the CD-RW drive to pin 1 on the sound card.
Warning:
Do not use mounting screws longer than 3x5mm to secure the
CD-RW drive or you may damage the unit.
secure drive with 3x5mm screws
audio cable
50-pin interface
ribbon cable
tab
notch
power cable
pin 1
CD-W512Sshort.fm Page 6 Thursday, December 14, 2000 10:30 AM
