ENGLISH
11
A
AC Power Cord
Plug this cord into an AC wall socket.
<
Unplug the power cord when you are not going to
use the unit for long periods of time.
B
Wireless LAN antenna
If you can use a wireless LAN in your installation site,
the unit connects to the LAN using the wireless LAN
antenna. Stand the antenna up to use it.
C
ETHERNET port
To use a wired Internet connection, connect the
ETHERNET port of this unit to the ethernet network
using a commercially available ethernet cable.
D
AUX 1 jacks
These jacks transmit an analog 2-channel audio
signal. Connect the components using commercially
available RCA pin cables.
Make sure to connect the cables as follows:
white plug
w
white jack
(L: left channel)
red plug
w
red jack
(R:right channel)
White
(L)
Red
(R)
White
(L)
Red
(R)
If you want to use a recorder (ex. a cassette deck or a
CD recorder, etc.) with the CR-H500NT, connect the
output jacks of the recorder to the AUX 1 IN jacks
of the CR-H500NT, connect the input jacks of the
recorder to the AUX 1 OUT jacks of the CR-H500NT.
<
Be sure to insert each plug securely. To prevent
noise and humming, avoid bundling the signal
interconnection cables together with the AC power
cord or speaker cables.
E
PHONO jacks
Connect the turntable’s RCA pin cable to the PHONO
jacks.
Make sure to connect the cables as follows:
white plug
w
white jack
(L: left channel)
red plug
w
red jack
(R:right channel)
<
Be sure to insert each plug securely. To prevent
noise and humming, avoid bundling the signal
interconnection cables together with the AC power
cord or speaker cables.
<
Moving Magnet (MM) cartridges can be used for this
unit.
F
SIGNAL GND
Connect the ground lead of the turntable to this
terminal.
<
This is not a safety earth.
<
If the turntable’s ground lead is not connected to this
terminal, hum noise may be heard.
EN_CR-H500NT_T_C.indb 11
09.10.6 5:31:26 PM
