12
Loader Utilities
Loader utilities provide a means by which the loader mechanism can be tested or
diagnosed. These utilities are meant for
TEAC
approved service personnel and
advanced users only. If in doubt, do not use these utilities.
System Information
These functions are used to display information about the various components
installed in the CD Autoloader.
PCA Info
Display the installed firmware level, amount of RAM and the number of writers
found in the system, and the number of writers licensed in this system.
Writer Info
Display Recorder manufacturer, model number and firmware revision. While it
is possible to use different writer types, and different firmware revisions, TEAC
recommends using the same writer type and the latest approved writer firmware.
Hard Drive Info
Display the manufacturer, model number and capacity of the installed hard drive.
Autoloader Info
Display Autoloader information.
Upgrade License
Enabled options can be changed via these functions. To get a new key to enable
new options contact
TEAC
or an authorized
TEAC
distributor.
Show Current Key
Display current installed options Key String. This Key String is pre-install to all
systems before shipping to customer.
Enter New Key
Enter a new installed options Key String. Entering this Key String can change
your installed options. Contact
TEAC
or an authorized
TEAC
distributor to get a
new key string. See the Entering Text section of this chapter for instructions on
entering text.
Setup Menu
These menus are used to select various options available on the Disc Publisher.